6.0 lb. Extra Power Firing Pin Spring/Striker Gen 1-5
6.0 lb. Extra power firing pin spring
For all Glock Gen 1-5
This Extra Power Striker/Firing pin springs are a must for all 45 ACP, 45 GAP & 10mm Glocks. These bigger guns use 9% heavier firing pins but come with the lighter weaker 9mm firing pin springs which will eventually cause light primer strikes. These springs are also highly recommended for all other Glock models to insure positive primer strikes insuring that your pistol fires. These springs are better than the Glock springs. You will feel little or no difference in your trigger pull weight. This spring is manufactured by Ghost Inc.
Fixed my issue
Posted by Ryan C Ouellette on Nov 4th 2020
Kept getting light strikes so I purchased the 6lb striker spring and haven't had any light strikes since. Very pleased with my purchase
Positive primer strike!
Posted by Richard Stephens on Oct 20th 2020
I had a problem with some light primer strikes in my gen 2 g21. The extra power spring solved this problem but the only negative is an increase in trigger pull.
Posted by Unknown on Oct 5th 2020
Threw one in my big 10mm and one in a custom 43 I just finished building. Absolutely the best quality hands down. Will not do anymore custom builds without one. 10 pack is worth it to just replace it in all the glocks on the shelf.
Posted by Matthew Winkeljohn on Jul 15th 2020
I had purchased the ultimate trigger kit from Ghost and installed tge 4 lb spring, which resulted in some light primer strikes. But when I went to change it, I had misplaced the 6 lb spring that came in the kit. I bought this to replace it and it works like a charm.
Posted by Larry on Jul 3rd 2020
This is a nice spring; works great in my TP9DA. 100% reliable, and dropped the trigger pull and feel nicely.
I will try the 4.5 lb spring later, but I don't expect it to be as reliable.
Great for my glock 30
Posted by Pascal B on Dec 20th 2019
Light primer strikes are a thing of the past. Would highly recommend especially in carry or defense pistols.
Posted by Unknown on Mar 15th 2019
I installed this 6 pound striker spring on a Canik TP9SFX to add life to the firing pin after reading reviews of metallurgy used on Canik's MIM parts. Works fine, no failure to fire.