4.0 lb. Firing Pin Spring/Striker Gen 1-5
4lb. firing pin spring
This a Reduced Power Firing Spring is for Glocks GEN's 1-5.
4.0 lb. Reduced Power Striker/Firing pin springs this spring will give you the lightest possible trigger pull weights possible.
Use these only for Target or competition shooting-NOT FOR SELF DEFENSE!!
If you combine this spring with the 6.0 Trigger Spring and a Ghost 3.5 lb Trigger you will get a very light trigger pull.
All GEN's 1-4
Posted by jack c on Oct 12th 2018
IMPORTANT PART FOR A TRIGGER JOB
Posted by Wm. Carroll on Sep 11th 2018
The trigger spring helps lower the weight of the trigger pull and this spring is the best. In competition settings where trigger reset is desired by shooter, the spring may be too light.
I wouldn't do it again
Posted by Matthew on Jul 12th 2018
Definitely lightens the trigger pull, its great on a competition gun or with very careful ammo selection for very soft primer cups. Ghost DID warns us not to use these in defensive guns. But since I demand more reliability in my competition guns and don't want to worry excessively about it actually firing when I pull the trigger I wont be keeping them. I have had at least a dozen light off center strikes in both my Gen 4 19 and my Gen 3 17, causing failures to fire, in about 80 rounds total. These springs come out of the gun and into the trash today.
Posted by Dean on Apr 6th 2018
This spring (4.0 lb. firing pin spring/striker spring) combined with the 3.5# connector, 6# trigger spring, and a reduced power firing pin safety plunger spring creates a nice soft break point on the trigger. This is $25 project. It's the best...
Trigger pull weight
Posted by Unknown on Oct 30th 2017
Helps reduce trigger pull weight. Easy install. Get the 3pack! One for you and one for a spare & one for a friend!
Reduced Trigger Pull
Posted by Unknown on Oct 17th 2017
I replaced my 5.5# striker spring with the Ghost 4.0#. Trigger pull was reduced from 4# 6oz to 3# 12oz. Nice, and no failures to fire during range session.