43 PLUS 15% MAGAZINE SPRING FOR GLOCK

Previous | Showing reviews 21-30 of 31 | Next

21. perfection

    Posted by bdevereux on Oct 12th 2018

    Works perfect for worn out magazines.

22. Perfect for the Hyve +2

    Posted by David on Jul 12th 2018

    I had installed the Hyve +2 with the stock spring but it wasn't locking the slide to the rear on the last shot fired. I purchased the 3-pack of springs for my G43. They arrived quickly and comparing them to the stock spring showed a substantial difference in length. Perhaps a third longer overall. Took a few minutes to switch over and now the slide locks to the rear as it should.
    
    Quite happy with the 3-pack and the price and shipping speed would be hard to beat.

23. Glock 43 mags spring

    Posted by Rene on Jul 7th 2018

    These are excellents springs for my wife Glock 43. She is a consealed carrier and the old springs were not safety foy her.
    Now , she carry her gun with confident thinking that in any case there will not a malfuntion with the gun.
    The price in this web site was the lowest found considering the quality of the product.

24. Works great!

    Posted by tfasano1@gmail.com on Mar 24th 2018

    I first purchased this to use with another manufacturers 3D printed +2 extension only to find that it was getting stuck somewhere and didnt work. I called Ghost for support and they recommended I use it with thier +2 extension. I was hesitant because it doesnt offer much in the way of support against your palm, however it did allow you to keep your butt plug in, which is always great! So I figured I would give it a try. Put a hundred or so rounds through it today and it is working great! Thanks Ghost!

25. Spring into action!

    Posted by Unknown on Mar 24th 2018

    Proved a weak magazine spring could be the cause of slide not locking back, which it was in my case. All fine now!

26. Best replacement mag spring out there

    Posted by Steve on Jan 17th 2018

    This was just what i needed to fix the feeding issues with my hyve +2 mag extension ( also a great product btw ). Will buy for any extra mags i purchase in the future.

27. Nice for +1 or +2 magazines

    Posted by Brian Kloosterman on Dec 5th 2017

    Stronger than ome, especially noticeable in plus 1 or plus 2 magazines.

28. Great product, thank you.

    Posted by David on Jun 18th 2017

    The +15% are a bit stiff and need some more use to get them just right. Customer service is awesome, I emailed expressing my concern and was told they would break in but that if I was not satisfied that he'd refund them. No need, I let them set for two weeks at full capacity, just got to the range today. One was almost perfect after a couple hundred rounds and the other could use one more trip to the range (who doesn't enjoy that) Thanks!

29. Worth it

    Posted by Jay on Jun 8th 2017

    Well made, stiff, Same number of coils, easy enough to install, just buy it if you are running any sort of aftermarket +1/+2/+3 floor plate and not using an extra power spring, These will assist in the reliability and are overall a really cheap improvement. Buy the 3 pack even if you only need 2 and save money and just put the spare away,

30. Definite improvement

    Posted by Unknown on Jun 1st 2017

    With stock magazine, I was getting frequent jams. The bullets too often weren't feeding into the tube. It good in a defense situation. The stronger spring has fixed the problem.

Previous | Showing reviews 21-30 of 31 | Next